Herbert123 hat geschrieben: ↑So 14 Jun 2020 09:37
Yes, that works. But as I explained earlier, even with holding down shift the steps are too large to be of use.
0.1 degree step is too large for you? By the way, i notice that it is impossible to type degree step smaller that 0.1. But same time you can move manually to smaller steps at large zoom levels.
Maybe it make sense to add 0.01 precision to type input values limit? Or add option in program settings to manually limit precision to type input to 0.1 or 0.01 or 0.001?
Previously I posted a request for making symmetrical drawings. The underlying cause was the rotate layer tool did not respect the rotation point.
Would that point get respected, it is much easier to make such kind of drawings.